Plumbers NZ is New Zealand's largest online plumbing, gas and drainage resource. Plumbing exam help, plumbing news, directory and free quotes.

Author Topic: Shower lining  (Read 634 times)

0 Members and 1 Guest are viewing this topic.

Offline CharlesK

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
  • Im new @ Plumbers NZ!
Shower lining
« on: September 02, 2021, 12:06:58 AM »
Hi, our 60's house has a built-in shower, concrete walk-in floor and is lined with Seratone which hangs down about 15mm and is proud of the wall so makes a good drip edge. This was all fitted 6 years ago by a local builder but the lower edge of it is all now rotting. Another builder has been to look and suggested that we just reline it but use some stuff called 'showerline' which is faced with aluminium. The shower is 1200 x 900 and three sides are clad, the fourth is open with curtains. Now, the question is that this second builder has quoted us $4000-5000 to remove and reline and we wondered if this is a sensible figure? Also, is the suggestion of this new material a good one? What is the inside part of it made of? ie is it the same as seratone? Views would be appreciated.


Offline Plumber

  • Administrator
  • Hero Member
  • *****
  • Posts: 735
  • Karma: +52/-2
  • ***#1 Plumber***
Re: Shower lining
« Reply #1 on: September 06, 2021, 01:35:03 PM »
Hi I have setup a discussion for this here:
Please note that the advice I am giving is only my opinion and not necessarily a fact.  Please refer to our terms and conditions.

Share via digg Share via facebook Share via linkedin Share via twitter

Similar Topics

  Subject / Started by Replies / Views Last post
Two shower heads in one shower

Started by gaz1

2 Replies
Last post August 22, 2010, 07:26:51 PM
by spud
how do I use an ice age shower?

Started by sam187

2 Replies
Last post February 06, 2017, 12:24:24 PM
by integrated
Delta Shower

Started by newguy

3 Replies
Last post June 22, 2011, 10:58:33 AM
by newguy
Shower problem

Started by boltlass

2 Replies
Last post February 24, 2017, 01:15:22 PM
by Plumber
Share this topic...
In a forum
In a site/blog