SEE ANY SPAM? PLEASE REPORT IT, TO KEEP OUR COMMUNITY CLEAN.

Author Topic: clearances from a external instantaneous water heater  (Read 21812 times)

0 Members and 1 Guest are viewing this topic.

Offline Macmole

  • Jr. Member
  • **
  • Posts: 10
  • Karma: +0/-0
  • question everything
Re: clearances from a external instantaneous water heater
« Reply #75 on: June 21, 2020, 03:28:04 PM »
I know this is an old post but does this statement from Rinnai classing it as a combustion inlet for an appliance mean there is only 500mm needed from the regulator vent ?. I come across a lot of installations where the bottles are just to the side of the infinity

https://rinnai.co.nz/attachments/docs/vent-terminal-location-as-nzs-5601-1-clarifica.pdf
SAOR ALBA


Share via digg Share via facebook Share via linkedin Share via twitter

Similar Topics

  Subject / Started by Replies / Views Last post
xx
Sakura SH-550A Instantaneous water heater

Started by Chris Downey

2 Replies
1569 Views
Last post March 18, 2017, 08:33:23 PM
by Jaxcat
xx
General Instantaneous water heater installation questions

Started by Rodza1

13 Replies
7520 Views
Last post August 21, 2013, 08:18:14 PM
by NZMoose
xx
HWC vs. instantaneous water heaters?

Started by molumania

1 Replies
2865 Views
Last post October 29, 2008, 09:49:48 PM
by Crankin
xx
Looking for an instantaneous Gas Hot Water system

Started by jrgasandwater

2 Replies
722 Views
Last post December 05, 2018, 05:43:48 PM
by jrgasandwater
 
Share this topic...
In a forum
(BBCode)
In a site/blog
(HTML)