SEE ANY SPAM? PLEASE REPORT IT, TO KEEP OUR COMMUNITY CLEAN.

Author Topic: help with question from past certifying exam  (Read 564 times)

0 Members and 1 Guest are viewing this topic.

Offline billyhealey1993

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
  • Im new @ Plumbers NZ!
help with question from past certifying exam
« on: April 21, 2020, 03:46:00 PM »
 A factory requires water to be supplied that gives a flow rate of 230 litres per minute at a pressure of 750 kPa at the outlets.
 The supply pressure is 835 kPa.
 Give the minimum diameter of the RPZD that can be installed to meet these requirements.

I know the answer is 64
but is there an equation or formula to find this out

Linkback: https://www.plumbers.nz/plumbing/1/help-with-question-from-past-certifying-exam/2513/


Share via digg Share via facebook Share via linkedin Share via twitter

Similar Topics

  Subject / Started by Replies / Views Last post
xx
Past Exam Paper question

Started by Jayp

2 Replies
2700 Views
Last post June 11, 2012, 08:32:38 AM
by Plumber
xx
Certifying Question

Started by Jayp

1 Replies
1031 Views
Last post March 18, 2015, 10:36:26 PM
by Piperfeeling
xx
certifying exam ?? Is this right

Started by sharks

5 Replies
2941 Views
Last post July 01, 2011, 05:39:59 PM
by TS
xx
Getting rid of Certifying Common exam

Started by woody

2 Replies
1682 Views
Last post October 19, 2011, 10:43:40 PM
by TS
 
Share this topic...
In a forum
(BBCode)
In a site/blog
(HTML)