SEE ANY SPAM? PLEASE REPORT IT, TO KEEP OUR COMMUNITY CLEAN.

Author Topic: Bottle Station Position.  (Read 1185 times)

0 Members and 1 Guest are viewing this topic.

Offline robbo

  • Hero Member
  • *****
  • Posts: 1259
  • Karma: +83/-7
Bottle Station Position.
« on: February 28, 2015, 07:44:33 PM »
hi guys, what do you think? nice and compact,cheers

Linkback: https://www.plumbers.nz/instantaneous-water-heaters/67/bottle-station-position/1841/

Offline Enn

  • Full Member
  • ***
  • Posts: 192
  • Karma: +22/-1
  • Ex-chef
Re: Bottle Station Position.
« Reply #1 on: March 01, 2015, 02:34:17 AM »
Too close to the gully which should be sealed at least, even tho it has a water seal so there is no way that any lpg gas could collect in the drainage system. Different story if it was a storm water drain.
Ha nice that they left just enough room next to the gully to position the bottles..... ::)

Just a couple of days ago I drove past a building (main road) and saw a 9kg bottle connected to a external gas water heater  sitting on top of a blue plastic barrel to reach the pig tail, no restraint chain.
And another i noticed on a 2end story roof lean to, must have had to reach out the upstairs window to change the bottle.. i must try to get a photograph.








''Never have so many been fooled by so few''
Plumbing is not a career it is a disease....

Offline robbo

  • Hero Member
  • *****
  • Posts: 1259
  • Karma: +83/-7
Re: Bottle Station Position.
« Reply #2 on: March 01, 2015, 09:39:00 AM »
hi guys, yeah Enn gully should be sealed and vented, don't know if an air admittance valve would qualify? I bet they only ever change the near bottle, cheers


Share via digg Share via facebook Share via linkedin Share via twitter

Similar Topics

  Subject / Started by Replies / Views Last post
question
DoL Position on Heights and Ladder use

Started by newguy

0 Replies
1743 Views
Last post March 23, 2012, 11:12:55 AM
by newguy
xx
gas water heater installation position?

Started by roberto

2 Replies
1126 Views
Last post July 01, 2013, 11:11:44 PM
by integrated
 
Share this topic...
In a forum
(BBCode)
In a site/blog
(HTML)